|
| |
Disarming and Silencing Alarms:
The OFF key is used to disarm the system, silence alarm and trouble sounds, and clear alarm memories.
1.
To Silence a Burglary Alarm and Clear a Memory of Alarm
Enter your 4 digit security code and press off
(1). This disarms the system and silences the alarm (or warning tones of a
Memory of Alarm).
Note the zone in alarm on the keypad
display, and make that zone intact (close
door, window, etc.). Now enter the
security code plus OFF to clear the keypad’s
Memory of Alarm
display.
EXAMPLE: XXXX (code),1(off)
2.
To Silence a Fire Alarm and Clear Memory of Alarm
Simply press the OFF key to silence the alarm. Then enter the
security code plus
OFF
sequence to clear the keypad's Memory of
Alarm display.
Bypassing Zones:
Use this
key when you want to arm your system with one or more zones intentionally
unprotected.
When bypassing zones:
The
system must be disarmed before you can bypass zones.
Bypassed zones are unprotected and will not cause an alarm if violated.
The
system will not allow fire zones to be bypassed.
Zones
are automatically unbypassed when the system is disarmed.
Type your code + 6 + zone numbers (see
below)
(Security Code) BYPASS Enter the 2-digit zone number(s) for the zone(s)
to be
bypassed (e.g., 06, 10, 13, etc.). Single digit zone numbers must be
preceded by a zero (e.g.
05, 06).
When finished, the keypad will momentarily
display a "Bypass" message for
bypassed zone number. Wait for all bypassed zones to be
displayed.
Arm the system as usual. When armed, the
arming message is displayed with
“ZONE BYPASSED.” To display bypassed zones prior to arming,
enter
your security code and press the [6]
BYPASS key.
Example: XXXX (code),6 (bypass),xx
(zone no.)
Chime Mode:
CHIME mode alerts you to the opening of a
perimeter door or window while the
system is disarmed. When Chime mode is
activated:
Three
tones sound at the keypad whenever a perimeter door or window is opened.
Interior zones do not produce a tone when they are faulted.
Pressing the READY key will display the open protection points.
Chime
mode can be used only while the system is disarmed.
To turn Chime Mode on/off
(system must be disarmed)
Example: Press your code + 9
(Security Code) + CHIME
The CHIME message appears when on.
Perimeter zones will cause a tone
when faulted.
The CHIME message disappears when Chime
mode is off.
|
